Breakout board to Telemechanique Altivar 18 wiring (Mach3)

[edipelangi]

Thanks for all the replies. The inverter doesn't have speed control from the front panel. According to the manual AIC and AI2 are already configured and certainly if I connect a 1.5v battery between com and AI2 the inverter runs at about 15% as one might expect. If connect directly between +10 and AI2 the inverter runs at full speed, again as expected. So no problem with the inverter configuration.

Having played around with Mach3 and thought more about this two things occur to me:

1. I can get Mach3 to switch the spindle relay on, but the spindle DRO does not display an RPM and altering the speed doesn't alter any of the numbers from 0. Surely, even with nothing connected it should show values if it is generating pulses?
2. The inverter is looking for 0-10v between com and AI2, but where does the BOB get 10v from if it only has a 5v power supply? Do I need the 12-24v supply connected? I can take 24v from the inverter.

hai agathon , nice to meet u here.

i got the same issue with my mach3 to control the spindle. i can turn on the spindle with mach3 and then the spindle run to max rpm 24000.
after that i can not control the speed anymore.

have u solved this issue ? i use the same BOB like yours and the HY 1,5 kw inverter.


regards,

eddy.

[Agathon]

hai agathon , nice to meet u here.

i got the same issue with my mach3 to control the spindle. i can turn on the spindle with mach3 and then the spindle run to max rpm 24000.
after that i can not control the speed anymore.

have u solved this issue ? i use the same BOB like yours and the HY 1,5 kw inverter.


regards,

eddy.

Hi Eddy - my spindle now working as it should, but I don't think I can advise about your set-up as I'm not familiar with your inverter. Maybe someone else here can help. David

[EddyCurrent]

If it's working now it would be a great idea to let others know what you did.

[Agathon]

If it's working now it would be a great idea to let others know what you did.

Actually, having just revisited setting up my spindle I find that I haven't solved the problem. I can turned the spindle on an off and punching in a speed alters the frequency but not as I expect. I will investigate further and post my findings.

[EddyCurrent]

Is this on the Picomax machine ?

[Agathon]

Is this on the Picomax machine ?

Indeed it is.

[EddyCurrent]

This is the manual for the bob, it shows which settings to make in Mach3
https://www.rockcliffmachine.com/wp-...ard-Manual.pdf

The attached picture shows how I would connect the bob to the inverter

1. assuming the bob relay contacts are N/O, use this on inverter LI1
this prevents the inverter giving output until the relay is energised
and LI1 is the default input for FORWARD.

2. You need an external power supply for the bob.
24v from the inverter can only supply 100ma
and is intended for logic I/O only.

3. connect the 0-10v output from the bob to AI1
the AI1 terminal is the default input for this speed
reference signal.