Threaded View
-
13-12-2016 #11
It can support the legacy machines but the DOS EEPROMS are below the threshold. The 2.1 EEPROM should will work with the existing card, the L on card seems to mean a coms problem but i cant for the life of me find out what it is! Beer tokens it is, i am determined to make VR Work for me in the short term.. what the value of beer tokens these days lol!
Cant say i have heard of the Dynomotion's KMotionCNC, do they offer a hardware package?
If i have to go down the conversion route i can see me using a pneumatic button release on the drawbar until i figure out the magic of the ATC.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
XHC Motion Card, MK3-III
By Tom J in forum Motor Drivers & ControllersReplies: 12Last Post: 14-11-2020, 11:46 AM -
Parallel PCI Card Experience
By andy0202 in forum Computer HardwareReplies: 11Last Post: 24-08-2012, 10:39 PM -
PCI parallel card / BOB
By artmin in forum Computer HardwareReplies: 11Last Post: 30-01-2012, 04:38 PM -
plan request connection card PCPPS
By ali hedi in forum General ElectronicsReplies: 2Last Post: 07-04-2010, 08:18 PM -
Controller card selection
By Hogout in forum Motor Drivers & ControllersReplies: 7Last Post: 14-05-2009, 11:26 PM
Bookmarks