Thread: VMC300 Toolholder question
Threaded View
-
14-12-2016 #1
Ok, I`m stuck here.
Looking at my toolholders for my VMC300, there`s a difference between them, and the toolholders at Coventry Toolholders.
(http://www.coveng.co.uk/group/covent...sy-change.html)
Mine has a machined groove in the top flange, and i do believe for my ATC holder(spring loaded fork). Se Attached Picture.
However the toolholders at Coventry has not :-\
Looking at the video on youtube, it seems they have 2 types. One With just the 2 notches on each side, and one With additional groove for a ATC Version With spring loaded fork.
Am i completely off track here, or is my assumption correct ?
Are there any drawings in some far away corner of the internet on these toolholders if i would make them myself ?
I could of course make my own drawing and plot it in.
They are a bit expencive if you need say more than 5-10pcs ER32 Easy Change Collet Chucks..
Any advice gents ?
Last edited by Proteus; 14-12-2016 at 11:21 PM. Reason: Forgot attachement
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Boxford VMC300 conversion & parts. Help really needed.
By Proteus in forum Boxford Vertical MillsReplies: 0Last Post: 13-09-2016, 02:13 PM -
How to remove coventry easychange chuck/toolholder
By Rabs in forum Milling Machines, Builds & ConversionsReplies: 5Last Post: 06-11-2015, 07:08 PM -
To usb,or not to usb,that is the question.
By Jumbo in forum General DiscussionReplies: 11Last Post: 17-10-2011, 09:21 PM -
question ...
By Wobblybootie in forum General DiscussionReplies: 6Last Post: 04-01-2010, 12:04 AM -
A question
By bodgeitandscarper in forum Gantry/Router Machines & BuildingReplies: 7Last Post: 02-12-2009, 08:30 AM
Bookmarks