Warco WM16 CNC Conversion.

[noyloj]

Yay!

Good news, having nothing to do today, since snow has further delayed the arrival of my UC300ETH motion controller, I pulled apart my old 'broken' Metrix 803B oscilloscope to see if I could identify the problem in preparation for my mill electrics/electronics and lo it was just a sticky switch! It doesn't get easier than that folks!

Gave her a good clean out inside at the same time I had her in bits... about an 1/8" of dust on everything horizontal!

Made a couple of mods cutting cables and putting in joiners to make her easier to pull apart, without a soldering iron, next time...

[noyloj]

Ok

UC300ETH motion controller arrived today... along with the bb2 (and some cables that don't quite work to connect the two. Damn it!)

Couldn't get it to power up contacted cncdrive.com and they diagnosed that the jumper behind the 5V power socket was in the wrong position... I had noticed it didn't correspond with the drawing in the manual but was too scared to swap it over in case the magic pixies fried my new board...

So the board powered up and eventually got recognized by my laptop.... that runs windows ten but doesn't have the dotNET 2.0 framework on it and wont allow me to install it... so on to Microsoft who have suggested downloading a later version of windows 10 and updating... PAINFULLY slow download that already dropped out once at 38%.

I'll leave her cooking tonight and see how the cookie crumbles on the morrow...

Gonna need to work out the electrics between the BOB and the drivers... PNP, NPN... who knows?

Someone here probably... or it's out with the Oscilloscope Captain Clingon!

[noyloj]

Windows 10 update is working now with the dotnet 2.0 framework.

UCCNC auto updated the firmware on the UC300 so they are playing nicely for the moment! I am using a direct connection from the laptop not through a router or switch... so I used a network crossover Ethernet cable not a straight one...

Wm16 Mill arrived today and I managed to split it into two and lug the pieces upstairs with the help of my neighbor.... Gonna have to find a good table or weld up a stand for her... The stand is probably the way forward... I've got some angle kicking about here somewhere... Could probably make it simply a skeleton and add sides and cabinet and/or drawer at a later date...

Currently transferring (via Ethernet LAN) all media and music from my laptop to my desktop so that I can strip it and set it up to run the motion controller and UCCNC and Mach3 and probably some other CAD software and bits and bobs related to the mill conversion... Must remember to rejig the LAN IP address etc. settings when I swap back the Ethernet cable for the motion controller...