Warco WM16 CNC Conversion.

[njhussey]

Just read your post again Jo and see your dilemma, clamp 2 bits of 3"x2" wood together and drill a 14mm hole or largest drill bit you have nearest that size if not got that size, equi spaced through the join. Do this twice and use them as clamps for your ballscrew. Then screw them down to a flat work bench/door (but maybe not kitchen worktop.....unless you're single 😉) with a suitable spacer underneath them so you can turn your die without hitting the surface. Screw down a batton parallel to your ballscrew 25mm offset from it and then make yourself a 345 triangle that you can use to slide against the batton thus keeping the die square to the ballscrew....

Sent from my HUAWEI VNS-L31 using Tapatalk