Warco WM16 CNC Conversion.

**noyloj** · 02-01-2017

I suppose that the higher power means that current switching will be slower... but not to any degree that will matter considering the maximum velocity these motors are rated at and the application that they are being used in?

**noyloj** · 02-01-2017

If I run them at plenty high voltage this should offset switching rates through the windings...

**noyloj** · 02-01-2017

The motors will never be under any real load and should never get warm either which will reduce internal resistance after extended periods and again offset speed at which current flow can be changed though the windings over smaller motors..

**Clive S** · 02-01-2017

Well you seem to have it sorted then. I have a WM18 mill with nema 23s with 2:1 reduction at 68V and am882 drives and it is fine.

You will need to do some more research if you think nema 34 8.5Nm are correct.

**noyloj** · 02-01-2017

I'll use what I've got and hope that it's adequate. I want to use the motors and drives for a much bigger CNC router project later... it's not really that important that this machine runs super fast it's not for production more for fun! But thanks for the input, I'll consider it when I build my next mill.

This mill is more to enable me to play with these drives and whatever controller before my router build.

Incidentally, I'm going to direct drive the Z axis... belts are just another link in a chain imo.

**noyloj** · 02-01-2017

I'll keep you posted as to how this pans out!

**komatias** · 03-01-2017

Hi, I sell a similar machine to the warco and am currently designing a sort of plug and play CNC kit with pro quality hardware that does not need you to machine the castings. If you are interested let me know.

**JAZZCNC** · 03-01-2017

Originally Posted by noyloj

Incidentally, I'm going to direct drive the Z axis... belts are just another link in a chain imo.

You have lot to learn Mr.!! . . And your not going to learn anything except how to waste money if your going to ignore advise from VERY VERY VERY experienced builders.

Motor size isn't all about speed and Belts are in no way weak link.!! . . . . Now suggest if your not prepared to listen then you go away quitely and research out why two experienced builders have used Smaller motor and Belts on larger machines.?