Warco WM16 CNC Conversion.

[John S]

We don't have moderators, only dictators

[noyloj]

Well certainly parts of the last word!

Jo A -
hole...

[noyloj]

I meant tators of course like mashed tators! Y'know?

[noyloj]

Of course if no-one knows HOW to move this thread I'm sure there are forums that could explain to you how to do it... And what colour shirt you have to wear whilst moving the thread.. and what hot beverage to drink afterward... etc...

[noyloj]

Ok I.ve spent an hour examining the differences between the Leadshine Hybrid motors and the jss-motors (Changzhou Jinsanshi Mechatronics) copies... the pinouts for the DB9 are quite different... this is not a good sign for me using the Leadshine motor tuning software... There is an outside chance that the eeproms of both are the same and I can use the software to Rx and Tx if I just get the pin connections right, but it's unlikely. I will see what jss-motors recommend for tuning... I think JMC offer a hand held tuning device for their hybrid motors, maybe jss-motors do the same...

[noyloj]

Still waiting for my UC300ETH and BOB and cables... Ho Hum! Would give me something to play with whilst I wait for the Mill to be shipped... never mind though I will catch up with some homework!

[JAZZCNC]

Of course if no-one knows HOW to move this thread I'm sure there are forums that could explain to you how to do it... And what colour shirt you have to wear whilst moving the thread.. and what hot beverage to drink afterward... etc...

Well get your self off then.!!. . . . . Sure with attitude like yours you'll go down storm there as well.

[noyloj]

Sense of humour failure!
But sure you must be right! How could I DARE to question! KMA! Hahahha!

[noyloj]

All hail the great Know Everythings who must be obeyed in fear of being 'canned'... Oh where's my mummy!

[noyloj]

Incidentally this is a build log. I don't remember asking ANY questions here. I asked questions in the other parts of this forum! Logic non?