. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 09-01-2017 #9
    Clive S's Avatar
    Lives in Marple Stockport, United Kingdom.
    Clive S
    Current Activity: Viewing MYCNCUK Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 3,339. Received thanks 618 times, giving thanks to others 81 times. Made a monetary donation to the upkeep of the community. Is a beta tester for Machinists Network features.
    Quote Originally Posted by terry1956 View Post
    hi, the microstep driver is a FMD2740C . apart from adding a power supply to it is there any other wiring that needs to be put in place. also how do you find the pin numbers from the card. thanks
    Ok they are 50V drives so you will need about 36 - 45 volt DC power supply.

    Also the dip switches you have them set at 0.5A which is far to low.. So set sw5 to on sw6 to off sw7 to on that will give you about 3 A

    Are you using mach3 or what?
    Edit I see it runs off usbcnc so I think this is the manual http://www.variometrum.com/PDF/USBCNC_csatolo_ENG.pdf
    Last edited by Clive S; 09-01-2017 at 06:03 PM. Reason: added text
    ..Clive
    The more you know, The better you know, How little you know
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 4 users browsing this thread. (0 members and 4 guests)

Similar Threads

  1. anyone using an e-cut 1 mhz usb breakout board
    By nobby in forum Control Hardware & Systems
    Replies: 10
    Last Post: 22-10-2018, 11:50 PM
  2. help needed with breakout board
    By terry1956 in forum Motor Drivers & Controllers
    Replies: 22
    Last Post: 07-09-2016, 07:58 PM
  3. Breakout Board
    By Tomnewry in forum General Electronics
    Replies: 2
    Last Post: 12-12-2013, 07:24 PM
  4. FOR SALE: PMDX-122 Breakout board
    By IN-WondeR in forum Items For Sale
    Replies: 0
    Last Post: 14-12-2011, 04:05 PM
  5. Breakout Board
    By croy in forum Electronic Project Building
    Replies: 10
    Last Post: 18-08-2011, 07:50 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules