. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 14-01-2017 #3
    Noddy's Avatar
    Lives in Poole, United Kingdom.
    Noddy
    Last Activity: 24-07-2017 Has been a member for 8-9 years. Has a total post count of 6.
    Thanks for that, it has a lot more info than the manual I had.

    I'm still not entirely sure if I have it connected correctly or not

    Click image for larger version.  Name: Screen Shot 2017-01-14 at 19.55.57.png  Views: 2814  Size: 579.5 KB  ID: 20369

    I have the X1 (FWD) wire from the VFD connected to pin 17
    I have the COM wire connected to the GND port on the board
    I have the 0 - 10V wire connected to the + port on the board
    Last edited by Noddy; 14-01-2017 at 09:32 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Bob for spindle control
    By Duffman in forum General Discussion
    Replies: 8
    Last Post: 29-12-2016, 02:14 PM
  2. [HELP] 6 Axis B.O.B with spindle control
    By birchy in forum General Discussion
    Replies: 7
    Last Post: 02-10-2014, 12:15 AM
  3. 5-axis Breakout Includes Hand-Held Control Port & 3,4,5-axis Postion-Display Port
    By LoveLearn in forum General Electronics
    Replies: 12
    Last Post: 25-05-2013, 12:41 AM
  4. Advice Needed - Control Panel
    By GTJim in forum General Electronics
    Replies: 0
    Last Post: 18-04-2013, 08:23 AM
  5. Help with spindle control
    By wizzy in forum Spindles & Drive Motors
    Replies: 4
    Last Post: 12-02-2011, 12:51 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules