10mm belt nema23

[kev20009]

Hi Dean,

It would not be advisable to get the am882 drives and a decent toroidal psu (I guess around 60v, you have more experience..)?

I see that he had invested a lot in his build but got stuck with some crap drives, and he only needs two of them.

edit:


Kev, I told you about the importance of setting up acceleration. Did you get the idea?

From your controller manual:

【Max Acc.】: Acceleration when axis making accelerated or decelerated movement. Too a big setting may lead
to motor losing steps or dither; too small setting may cause slow acceleration and then slow
processing speed for whole image. For axis with big resistance, such as Y axes corresponding
with beams, typical setting should be within in 800～3000mm/s2 ; For axis with small resistance,
such as X axes corresponding with carts, typical setting should be within in 10000～
20000mm/s2;

Yes all the settings in there are ok and as been altered to suit, all these do is if your cutting then it moves to the next cut, it accelerate to fast and lose steps, or to slow moving to next cut, the speed settings are when your in the layers, as fast for engrave slow for cut,