At the time when i wrote that, it was just Mach3. Then i managed to work out all the pins by trial and error.

It worked really well. Since then i tried to calibrate via settings Alt6. I hit the reset button in there, it now doesn't do anything :S - Well i hear the Control board click every now and again.

Quote Originally Posted by JAZZCNC View Post
My preference would be from Cslabs but not cheap depending on if you need slaved motors or not. However the UC300ETH would be my second choice provided it's connected to good breakout board that can provide 24V I/O.



When you say Mach is setup do you mean it's just been installed or you have set it up with all the correct pin numbers etc.
Just installing mach3 won't make the mach work. To work you need to tell mach3 where to look for incoming signals and where to send out going signals. To do this you'll need some info about how the machine is wired. This is known as the I/O system (input/Output) and if set wrong machine won't do anything.

If you don't know which pins are connected to what and can't get the info then you'll need to take very detailed pics and post so we can work out what hardware you have and whats going to where.