El Beast - Initial design phase, comments and critique welcomed!

[AlexDoran]

Looking great as usual

[Zeeflyboy]

Good to know - thanks for the info!

So I needed to make a little doo-hickey out of titanium to allow me to rack the side panels (note, titanium screws too!)






Parts degreased and after a quick etch and Desmut:




Dyed and laser etched... I did two different etches here, the honeycomb was at a higher speed and lower power which has given it a nice grey effect that looks better in real life than on the camera. Was a bit worried after doing this that it was too bold and in your face, but having assembled it I really like the look as part of the overall assembly.




That done, I put together the bulk of the Z-axis after the anodising. Only the big front plate left to do but I need to figure out how I'm going to seal it as the only suitably large vessel I have to boil it in is a 60L drum which will take a loooong time to get to the boil with a 1.5kw heater.

[Chaz]

Fcking amazing work as ever.