El Beast - Initial design phase, comments and critique welcomed!

[Zeeflyboy]

Little more work today, I need to tidy things up a bit in the man cave so good excuse to get the motor mount plates made - allows me to install the screws and motor mounts to start getting things off my desk!

10mm eco-cast plate, done in much the same way as the other parts so far:

First fix:




Drilled and countersunk:




Second fix, finished:




Haven't got all the fixings I need (e.g. no countersunk screws long enough etc) but good enough for a test fit, motors are also placeholders. Motor mounts have 6mm dowel pins for alignment purposes: