. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 03-09-2017 #11
    Zeeflyboy's Avatar
    Lives in Nowhere, United Kingdom.
    Zeeflyboy
    Last Activity: 13-07-2023 Has been a member for 7-8 years. Has a total post count of 440. Received thanks 229 times, giving thanks to others 60 times.
    Made one of the screw mounting plates:






    Flipped for the rear side, it was previously held down at the near edge too but I removed the front clamp to run the chamfer.




    Unfortunately it's way too tall to fit into the CNC for drilling the sides, so I 3D printed another jig and made some drill bushings on the Lathe:






    Nice snug fit:




    Drilled and tapped:




    Assembled:






    Fitting to the machine reminded me that I need to flip the nuts on the screws and also showed a small design tweak that's required to then give the nut clearance, other than that though the fit is spot on regarding heights and spacing.
    Reply With Quote Reply With Quote

  2. The Following 2 Users Say Thank You to Zeeflyboy For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 4 users browsing this thread. (0 members and 4 guests)

Similar Threads

  1. Initial design advise wanted
    By driftspin in forum Gantry/Router Machines & Building
    Replies: 45
    Last Post: 24-10-2017, 06:55 PM
  2. Initial Design Check Please
    By Gotty101 in forum Gantry/Router Machines & Building
    Replies: 90
    Last Post: 28-02-2017, 07:53 PM
  3. Critique required on y-axis design.
    By Spedley in forum Gantry/Router Machines & Building
    Replies: 2
    Last Post: 06-05-2013, 09:17 PM
  4. About to build CNC miller, need design critique please
    By JW149 in forum Milling Machines, Builds & Conversions
    Replies: 8
    Last Post: 23-04-2012, 09:28 PM
  5. NEW MEMBER: About to build CNC miller, need design critique please
    By JW149 in forum New Member Introductions
    Replies: 1
    Last Post: 22-04-2012, 07:01 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules