The Y was out about 0.5mm and the X was out about 0.2mm.
I think that is okay on the inside but on the outside obviously that is too much.

Thinking about probing off the stock instead and then I should be perfect when I flip and obviously proble off the same corner when flipped.
That should result in a perfect (excluding the machine's accuracy, which they say is "0.05mm").

I can't find any none hand made ones that would fit. Like you say they are for mills. Shame because the Haimer ones are good price and easily available here. If only there was another 3-4cm of Z travel and I could use it, though 20mm bore xD
Which one did you end up with Zeeflyboy? I remembered you linked one but it was out of stock for a long time.


I've seen a few people use tape. Sometimes using standard double sided 3M and having great results. I might go buy some tomorrow actually and try it.