Newbie looking at 6040 (China CNC) for polypropylene 15mm sheet

[JOGARA]

Thanks for all the info.
I have been using the tool bit to touch off for a while and get okay results. Was hoping the probe would be better and faster.

I have 2 holes in my soft jaws to use as touch off points. I might try and use that method instead of touching off the edges.
The ProbeIt thing is acting up though with the auto probing. Probes something then fucks off somewhere....


Trying to use this bit to make my Fillets. https://www.shop-apt.co.uk/corner-ro...ide-45hrc.html
I am not 100% on the Fusion tool library and can't find examples for this sort of tool.


NOTE, Diameter is set to 1.3mm and shaft to 8mm. This image is old.

I got it to work though it was either too close to the part on the XY or too high on the Z. Not used it in over 2 months.
Any ideas?



I'v been cleaning mine out too. Not noticed any difference though I have not been looking.
For me it gets clogged up in the collet so when removing the tool I blast it.


[edit]
Think I got it working now. Though speeds and feeds are probably wrong.
Lots of chatter.