Dual drive Gantry, how fast are your speeds?

**Clive S** · 21-02-2017

Originally Posted by dachopper

I'm running a uc400 Ethernet motion controller, no parallel or USB,ports. At 400hz. What type of motion controllers would be a lot faster

I suggest you re read your other post http://www.mycncuk.com/threads/10592...-problem/page4

And sell your drives. Have you had a response from the manufactures yet?

**dachopper** · 21-02-2017

Yes, they posted replacement part which I installed, and which works better than the original part but still not 100%( I had the voltage down at 42 , I found a linear non regulated power supply that they recommend, and I will try that out. My recommended voltage is 53.5 for my motors, I'm pretty close to that now.