Running 4 1605 screws

**Clive S** · 22-02-2017

When you set this up did you start with all the nuts at the top before you put the belt on? or loosen the grub screw on the pulley and then turn the screw to the correct position and then retighen

**kev20009** · 22-02-2017

Originally Posted by Clive S

When you set this up did you start with all the nuts at the top before you put the belt on? or loosen the grub screw on the pulley and then turn the screw to the correct position and then retighen

hi clive yes done it where I could turn the belts and pulleys before tighten grub screws, put nuts top bottom and middle with a gauge block,

**Boyan Silyavski** · 22-02-2017

These are things i do with Locktite, and i mean not the instant glue from grocery shop

**kev20009** · 22-02-2017

guys not sure if this is a stupid thing to think, but looking at all the nuts none off the plastic ball carrier matches each other, some are at bottom some are 6to7mm up, so could this effect what im trying, thanks again kev