Cambam with Mach3

[ladybreaker]

The tool is 2mm cutter ,some slots which are 3mm wide but the rest are more than 10mm

[Clive S]

The tool is 2mm cutter ,some slots which are 3mm wide but the rest are more than 10mm

Ok if nobody answers I will load your gcode into Mach3 in the morning and see what it does.
edit: I have loaded it in CamBam and you appear to have a cut width peram set to 3 but you are using a profile tool path. I am not familiar with CB so not sure if that is correct.

Can you set this to auto and test again.

[Neale]

I've just loaded the .nc file into Mach3 and the toolpaths all show up.

[Clive S]

I've just loaded the .nc file into Mach3 and the toolpaths all show up.

Thanks Neale saves me a job. Out of ideas then.

[Fred]

Same here. All toolpaths look OK in CamBam and Mach3. I'd suggest is that you set your target depth to -3 rather than 3. but CamBam corrects this anyway. About to make a comment about the cut width then realized Clive has already done so.

[Clive S]

Same here. All toolpaths look OK in CamBam and Mach3. I'd suggest is that you set your target depth to -3 rather than 3. but CamBam corrects this anyway. About to make a comment about the cut width then realized Clive has already done so.

Yes the Gcode shows -3mm so no prob there. Not sure about the width peram set to 3 with a 2mm cutter and a profile pass!!

[paulus.v]

Something is wrong with your mach3 not the g-code. I have the mach3 demo installed for testing purposes without any settings altered. Your g-code shows up and runs perfectly.