Help needed with Mach 3 - reset external flashing light

[JAZZCNC]

Paulus.v is correct no matter what sophisticated script or code we use outputs are disabled in reset mode - so I try piss against the wind here.

Dean do you have any idea?

Ah but he's not using the IP-M so can't talk directly to the controller like you can and bypass Mach3. Now your going to see little of the beauty of Cslabs controllers.

To do this you need to turn on Macro pump option in mach3 config and use macro to talk directly to the controller to tell it to turn on the output when goes into reset. You will need to re-start mach3 after selecting macropump.

Here's one I created to watch cycle start, feedhold and reset then turn on outputs when active. You can use it for the same job just don't use the cycle, f-hold outputs.
I've set it to use output #1 but you can change it to any output# you want to use by opening file and changing the constant "idleresetlamp" found near top of file.

Don't change the file name it must be called Macropump and put it in the Macro folder for each profile that uses it.

Let me know if any probs but use it at your own risk I take no responsabilty if doesn't work or messes up.