Fusion Problems

[Neale]

So it looks as though I am set up to learn Fusion now.

...and you'll never look back! Takes a bit of getting used to, as the whole approach to "modelling" with a tool like this is rather different to the "drawing" approach of older 2D CAD. but it gets to be a natural way to do things. The CAM side is pretty handy, too, with things like adaptive clearing easily available. I like it a lot. I still use Vectric VCarve, though, for things like lettering as it is just so good at doing that, and the CAM side works very well at the v-carving side of things.

I run F360 on a couple of machines with at least 1GB graphics cards - but given that my garage machine that just runs the router needed a graphics card replaced, and a 1GB card cost less than £25, that seems to be classed as "entry level" these days...