Threaded View
-
07-03-2017 #3
Hi SweetAs,
The worst bit, for me, about the build you link to, is the single rail on the y-axis!!
Practically every cnc build i have seen has two rails. One just seems daft.
It's a bit like trying to dig a hole with a shovel using only one hand !!
Here's a thread with a few completed builds to peruse http://www.mycncuk.com/threads/10066...s-picture-menu
Prob the best way to get advice from the wealth of experienced builders here is to research an initial design and post it up for review.
CheersLast edited by Greeny; 07-03-2017 at 12:52 AM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Denford router - Brushed router too brushless spindle - Help and advice please
By Tom B in forum Brushless Spindles & MotorsReplies: 4Last Post: 16-05-2016, 09:13 AM -
BUILD LOG: my router build - advice needed
By thomashomer1986 in forum DIY Router Build LogsReplies: 10Last Post: 02-12-2013, 11:45 PM -
Looking to buy a ~4'x4' CNC router, advice welcomed
By Franco in forum Marketplace DiscussionReplies: 1Last Post: 02-06-2013, 10:05 PM -
Help / Advice is this cnc router worth £666 plus £100 for postage
By dannyj2009 in forum Marketplace DiscussionReplies: 6Last Post: 10-04-2013, 01:29 PM -
Advice on which cnc router
By Xenophya in forum Milling Machines, Builds & ConversionsReplies: 0Last Post: 08-10-2012, 11:25 PM
Bookmarks