Threaded View
-
09-03-2017 #1
Maybe ;)
Looking at getting one of the eBay offerings, all seem the same, probably a 60W model so i end up with about 30-40W at the cut.
Watched loads of videos, realise the machines, as most chinese stuff does, needs a lot of fettling and tuning, realise that they over-drive the tubes to get more out - bad idea, and so-on so hopefully there will not be too many surprises in store.
First question - most vids show them cutting white card/paper, supposedly because it looks good and shows defects well. I have a possible task in mind that uses BLACK card, about 0.25mm thick - will they cut this as easily? My guess is yes but...
I was looking at building one but there is no way to put even the motion together for what these machines are going for so buying and fixing is the way forwards.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Please don't push 14A through that PCB !!!
By Jonathan in forum General ElectronicsReplies: 9Last Post: 05-01-2017, 04:43 PM -
FREE: Green/Red/Black 3P push button rocker switches
By Lee Roberts in forum Classified Ads, Buy, Sell & SwapReplies: 3Last Post: 08-05-2016, 07:38 AM -
Help with Mach 3 REF all Home Button
By Kevin1970 in forum Artsoft Mach (3 & 4)Replies: 11Last Post: 23-04-2015, 10:54 AM -
push down plate,
By jcb121 in forum Gantry/Router Machines & BuildingReplies: 0Last Post: 31-07-2013, 11:38 PM -
Donate Button
By Ricardoco in forum General DiscussionReplies: 8Last Post: 08-09-2011, 10:32 PM
Bookmarks