I've been lurking around these forums for a while now, and following this thread with interest. I have a project in mind that would require the use of a laser cutter. My initial investigations have lead me to believe that the same model of 60W cutter would be best suited to my requirements, and meagre budget!

My main issue is that to get to my workshop, it will have to pass through a fairly narrow gate and negotiate a tight turn between two brick walls 900mm apart. The machine will have to be un-crated outside, and tipped on it's side to get it through the gap.

To make this easier, is it possible to remove the legs under the machine, and if so what would be the dimensions with the legs removed?

If it's not possible to remove the legs, I'll probably need to get the builders in to make some modifications to the corner, or choose a smaller model instead.