Ok. The spindle and the VFD.

So you have GDZ or similar 230V Spindle 3 phase?? right capable of 24k rpm????? + 230V 2 phase VFD


You have just a couple of buttons connected. I can not see from here which is which so you have to trace them and program them again, after you finish programming the spindle.

Ok, step by step:

-PR133 1 restore factory settings

-PR000 4

-PR001 4 / dont forget later to check buttons if connected properly

-PR003 1 / you will never need reverse run

-PR008 1

-PR027 220

-PR29 400

-PR033 400 / that possibly is not set right at the moment

-PR038 400

-PR039 0 / so motor works from 0 to 24k rpm, obviously no much torque when less than 3k rpm/

-PR040 10 / 3-5 is also ok for that motor, but 10sec to be on the safe side/

-PR104 to PR111 - check if you buttons are properly programmed, / start stop etc. You don tneed reverse, so use it for sth else/


So thats it. It should work ok now.