Way out of my depth

[jenxmetalworks]

Ok I've had another look the encoders have incr encoder utoph 20a wm written on them here are more photos of Bob
The two LEDs on the left go on and off when I flick home /limit x and y the led on the right says pause if I disconnect the wire it goes out but still no movement

Here are the motor outputs there are two for each motor at the bottom the two at the top are 5v and ground is this motor enable?
Here are my isolated out puts could one of these be motor enable?



Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

[Paul3112]

Just out of curiosity, where does the cat 5 ( blue cable above top leds) go? It is saying output on the board silk screen.
Do you know how this machine was able to get ( g ) code? was it manually input via a keyboard? or downloaded via a disk/USB? or was it networked?
Are there any manuals for the servo drivers? Am thinking that it will show in the current config what the output from the board will be step and dir or pwm
when you say you get DRO movement, is that when you push the gantry manually or when you hit the keys in Mach3?
what was the logic for pin out assignment in mack3
Sorry for so many questions and no solution to the problem.

Good luck

Paul