Spindle help to EDING CNC

[D-man]

What would be the best way to wire that up then, you saying I need a relay?


Sent from my iPhone using Tapatalk

[D-man]

should i turn the speeds off and just use FWD?

[JAZZCNC]

What would be the best way to wire that up then, you saying I need a relay?


Sent from my iPhone using Tapatalk

Depends on Eding outputs and I've never used it so can't tell you. However using relay removes any posibilty of damage and is simple.

quick look at manual shows it's possible to use method I suggested see sec 9.2 it shows simple wiring setup.

If not got relay then for test just setup the 0-10V side and simply short wire between FWD and CM to see if spindle comes to life at the speed set in eding.

[JAZZCNC]

what is set in accel setting param f0.10 set it to high number to test try 20

[D-man]

what is set in accel setting param f0.10 set it to high number to test try 20

So wire up as per picture and change parameters you mentioned and also accel ?


Sent from my iPhone using Tapatalk Pro

[JAZZCNC]

So wire up as per picture and change parameters you mentioned and also accel ?


Sent from my iPhone using Tapatalk Pro

Yes if it starts then try lowering the Accel until it doesn't. Usually around 4-6 will work ok but depends on spindle.

[JAZZCNC]

Look slike you have no speed set so it's running but at Zero speed.

[D-man]

Look slike you have no speed set so it's running but at Zero speed.

Ok gimme a min to wire up as per pic


Sent from my iPhone using Tapatalk Pro