. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 24-03-2017 #24
    magicniner's Avatar
    Lives in Rotherham, United Kingdom.
    magicniner
    Last Activity: 05-05-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 2,021. Received thanks 230 times, giving thanks to others 42 times.
    If your mill doesn't cut circles that are round one assumes you'd realise thread milling isn't for you but if you haven't done any thread milling and so haven't read around the subject to a reasonable extent then this-

    http://www.productionmachining.com/a...g-makes-sense-

    Might help with understanding Thread Milling and it's capabilities :D

    Note. Better Finish, Lower Power Requirement and Fuller Thread Profile than tapping ;-)
    - Nick
    Last edited by magicniner; 24-03-2017 at 03:46 PM.
    You think that's too expensive? You're not a Model Engineer are you? :D
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Single Point Thread Mills
    By matt-b2 in forum General Discussion
    Replies: 9
    Last Post: 18-01-2016, 08:06 PM
  2. CONVERSION: Re-Built a used CNC mill machine to the point of 80%
    By dudz in forum Conversion Build Logs
    Replies: 13
    Last Post: 20-03-2014, 06:44 PM
  3. Setting the zero point on a CNC lathe
    By Robin2 in forum Lathes, Lathe Rebuilding & Conversions
    Replies: 7
    Last Post: 20-10-2013, 10:37 PM
  4. Setting the zero point on a CNC lathe
    By Robin2 in forum Machine Discussion
    Replies: 7
    Last Post: 20-10-2013, 10:37 PM
  5. Setting a start point.
    By jrob3rts in forum Computer Software
    Replies: 14
    Last Post: 17-06-2012, 12:36 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules