DIY Pin Badge

[Wal]

Hi,

I use cold enamel - like this:

http://brightenamels.co.uk/documents...e%20(2016).pdf

It's good stuff, but can be tricky to mix in small quantities, ie. 0.1gm colour + 1.9gm resin +1gm hardener. Too much/too little of one or the other and it doesn't set properly..!

If I'm using >0.8mm cutters I'll cut to a depth of 0.75mm, anything under that I'll keep to around 0.5mm - in both cases it's probably too deep, but I get paranoid about belt sanding through the epoxy..!

Wal.