Help with THC wiring

[TCF Engineering]

Thanks for the info, my friend was just here with me reading and now we understand. 1 more question, what is the best method to cut into the ribbon cable ? Can you get a special kind of connector, or do you literally have to cut into it with a knife and strip the wires back ?

Thanks so much for your help, we would not have figured it out without it

[m_c]

Some kind of connector will most likely exist however I've never seen one.
I'd personally just cut the wire, extend them by soldering on some extensions, then heat shrink over them. Done well it'll look reasonably tidy.

One other thing, is once you've cut the wires, you could try moving the axis before wiring in the THC just to make sure you've cut the correct wires. If you've got the correct wires, the Z should not move, but everything else should still work.