Water table build.....

[Skiprat]

Got the table bent and welded together......not too keen on my welds as its the first time i have done stainless TIG.

Had a few test goes then straight into deep end........Should of had a few days practising but hey that,s me..

Welded the steel square ready for the straight pieces and lats but leaving that until another day....hopefully tomorrow.

Tried welding the holes in but that was a bit sh111tty too say the least so i will leave that bit until i have had a few more practises plus i need to watch a few videos as the settings i used were just the basic ones out of the manual and they kept burning through as seen in photo.