PDMX 126 with AM822 drivers and relays.

[dachopper]

More progress,

Control box almost complete now with off latching e-stop and reset switch

Black is AC power in
White is relay controlled AC power out for Spindle / H20 pump / Chip extractor
Small black is always on DC power for the UC400 controller + feed to the PDMX BoB


Internals....
68V AC->DC converter on the left, with 12VDC supply off that holding a 40A/250AC Solid State relay at the back closed.

5x882's in the middle, ( still awaiting the tuning cable to arrive )

PMDX 126 on the right.

Still to come - install + connect the UC400ETH, secondary E-stop circuit to the E-stop button from PDMX, limit switch wires & stepper motor connectors on case, cooling fan