New build with recycled parts on a ridiculous budget 120cm*60cm work area

[Desertboy]

Was playing in fusion only took 40 mins but not sure how I'd drive the long axis, I think needs to be R&P but have no idea how to set up a dual pinion anti backlash setup. The other choice 2* 2.7m 2510 ballscrew's with rotating ballnut's as at the length it's going to be a skipping rope if I try and rotate the screw.

Does anyone know how I invert the axis in linuxcnc? Using the beta dual ballscrew on the Y so need to edit the hal or .ini to do it as the wizard doesn't support dual motors.


Alright Fusion buffs when I copy an object how do I break the association so my edits to the new object do not effect the original?

[Davek0974]

Man, do i need to brush up on Fusion, 40 minutes? would have taken me a week :) Thats if i could figure out where to start

[Clive S]

Does anyone know how I invert the axis in linuxcnc? Using the beta dual ballscrew on the Y so need to edit the hal or .ini to do it as the wizard doesn't support dual motors.

Dave

For twin screws you need Linuxcnc V 2.8 master if you want independent homing. I you want to reverse on of the motors then you can just swap the phases around on the motor.

What version are you using?

[Desertboy]

Dave

For twin screws you need Linuxcnc V 2.8 master if you want independent homing. I you want to reverse on of the motors then you can just swap the phases around on the motor.

What version are you using?

It's not Dave it's me ;) I'm using the beta I've enabled the master repositories so should be bang up to date, it's does read 2.8 something on boot.

I was hoping it was just an option in the ini to invert them you can do it from the stepconf but that's no good for setting up dual ballscrews.

I guess swap the wires around will be the easiest solution.

My brother asked me what I want for Xmas was going to ask for a 3nm nema 23 which I'll fit to the gantry and swap the 2nm from the gantry to the Z.

[Clive S]

It's not Dave it's me ;) I'm using the beta I've enabled the master repositories so should be bang up to date, it's does read 2.8 something on boot.

I was hoping it was just an option in the ini to invert them you can do it from the stepconf but that's no good for setting up dual ballscrews.

I guess swap the wires around will be the easiest solution.

Sorry Me Can you post your ini and hal files and I will take a look, you can invert them in hal. I am In Spain again but back on Tuesday but I might be able to do it from here.

[Desertboy]

Sorry Me Can you post your ini and hal files and I will take a look, you can invert them in hal. I am In Spain again but back on Tuesday but I might be able to do it from here.

Enjoy the sangria & sunshine ;)

[Desertboy]

Got my MDF bed on now I need to make it a vac bed ;)

I used an 18mm sheet

[Nr1madman]

Got my MDF bed on now I need to make it a vac bed ;)

I used an 18mm sheet

Pics or it didnt happen :D

Skickat från min SM-G955F via Tapatalk