New build with recycled parts on a ridiculous budget 120cm*60cm work area

[Desertboy]

Dave

For twin screws you need Linuxcnc V 2.8 master if you want independent homing. I you want to reverse on of the motors then you can just swap the phases around on the motor.

What version are you using?

It's not Dave it's me ;) I'm using the beta I've enabled the master repositories so should be bang up to date, it's does read 2.8 something on boot.

I was hoping it was just an option in the ini to invert them you can do it from the stepconf but that's no good for setting up dual ballscrews.

I guess swap the wires around will be the easiest solution.

My brother asked me what I want for Xmas was going to ask for a 3nm nema 23 which I'll fit to the gantry and swap the 2nm from the gantry to the Z.