New build with recycled parts on a ridiculous budget 120cm*60cm work area

[Desertboy]

Was the air Blue

I'm not a violent man that's why I paid some crack heads to break his legs

[Desertboy]

Managed to do 10 bolts without a Tap but hard hard work take note the size of lever lol. Ran out of bolts now when the rest come the tap will be here as well.



2 pieces making the bottom frame are 6045 extrusion which makes it look a little odd. I wonder if I spaced them close enough together the gap is less than 30cm between each extrusion will have an 18mm MDF board on top

I'm impressed with KJN's cuts the frame fits together perfectly. I had the outer frame cut from 9045 ages ago then had them cut the 4545 and 6045 that make the bed up the other day. Other places I;ve used they would not fit properly.

Need to have a think about legs I want to have a shelf underneath so I can put vacuum cleaner & cyclone, water cooling, etc on the shelf to keep things neat and under control.

[Desertboy]

Now looking at it I realise I need to add more supports for the bed I have another piece of 6020 I can cut to 2 1m pieces and if I buy 2 more pieces (£24) then I could do this for the bed


With a a sheet of MDF on it I think it would be ok.

I wouldn't have the frame drilled I would just use corners and T nuts I have enough kicking around.