1200mmX900mmX170mm 4axis cnc

[Nickhofen]

UC300 with UB1 will cost 320$ with out shipping and taxes,this is far away from badget right now.....

[Desertboy]

I feel your pain, that's why I setup with PP BOB originally as the budget just wouldn't stretch over Xmas period so I could play with it, do some calibration and decide if I got on with linuxcnc before spending £300 on hardware which locks me into a vendor I haven't even tried.

I remember you saying you've used mach before so being locked in is probably not an issue to you.

When I was able to sell a kidney I got my electronics ;)

Ironically now I have a machine with good latency I can run it at 9m/min no issues from the PP BOB with 8 microsteps which has made the mesa less essential but obviously I'm still going to use it.

[Nickhofen]

Yes you remember correctly,I am going to use Mach3 again.
My new senario is to take the uc300eth-5LPT and a crap break out board until I decide which of two kidney to sell,haha!!

[Desertboy]

Yes you remember correctly,I am going to use Mach3 again.
My new senario is to take the uc300eth-5LPT and a crap break out board until I decide which of two kidney to sell,haha!!

You can also sell one of your eyes and part of your liver ;)

[Nickhofen]

You can also sell one of your eyes and part of your liver ;)

Ahahahhahaa!
I need both my eyes for my job,but I have a big nose that I can partially sell to get money for my bob....:-P

[Nickhofen]

I "see" the bob problem coming and finally fix it!!!

Hahaha photo from cnccook book!

[Desertboy]

I "see" the bob problem coming and finally fix it!!!

Hahaha photo from cnccook book!

Sometimes you have yourself do I really need all that blood ;)