1200mmX900mmX170mm 4axis cnc

[Clive S]

Thanks guys!
Clive CY4 core for the motors and parallel wiring for the motor's coils right?

Yes 1mm cable is ok. and parallel assuming you have 8 wire motors yes

[Nickhofen]

8 wires of course,I forgot to mention it

[routercnc]

My layout is a mirror image of that because the VFD air inlet is on the left. I cut out a large hole in the side of the enclosure next to it to allow the air straight in to the VFD and the it exhausts out of a hole directly above it. That stops it drawing warm air from the enclosure.

I allowed 2 80mm fan sized holes in the base of the enclosure below the drivers but never added the fans as they barely get warm. Natural convection seems to work fine although we are in the UK so it does not get that hot.

[Nickhofen]

Thanks routercnc.
I have in mind to use two fans on the bottom of the enclosure box to push air in there and a filter for the dust and two on the top.
The info about the hole near VFD is very good,I am going to use it!

[Nickhofen]

This week a friend ask if I want one of those big PC tower for housing the electronics of the cnc, I said yes and he came with a box bigger than I could think!
Ι did some mods on the box...

[Nickhofen]

Some more drills, screws, rivets and , here is the result!

[driftspin]

Some more drills, screws, rivets and , here is the result!

Hey Nick,

I like it that you are making progress.

Keep up the good work.

Grtz Bert.




Verstuurd vanaf mijn SM-A320FL met Tapatalk