1200mmX900mmX170mm 4axis cnc

[Nickhofen]

Thanks for the reply Desertboy, I will go for shielded cables then, the cost is not much higher than the non shielded, so it is better to be CY and block all interfierence that I can.

[Desertboy]

All modern VFDs use power devices known as IGBTs. These devices make it possible to minimize annoying audible noise by using switching frequencies beyond the audible range. Unfortunately, VFDs using IGBTs, present a high potential for generating RFI - Radio Frequency Interference.

http://www.vfds.org/vfd-and-rfi-708163.html

[Nickhofen]

Nice site,many good info there....

[Nickhofen]

I've been waiting for 42 days for the T slot nuts to come from China and finally come and with them the frustrating reality!
Nuts was shorter by .20 and this make them turn and not lock in the aluminium slot!
I cover the T nuts with self adhesive tape and solve the problem, this took me one day to think it since my nerves was not in good condition,as I was keep thinking that if I make a new order, it will take another 40 days to arrive!

[Nickhofen]

Put the rails on the aluminium extrusions and run the caliper.

[Desertboy]

I'm going to glue 2 T nuts together so they can't twist in the slot for my clamps to make it easier to release, move and retighten.

Is that M6 thread with a 10mm slot?

[Nr1madman]

I'm going to glue 2 T nuts together so they can't twist in the slot for my clamps to make it easier to release, move and retighten.

Smart stuff ;)

Or you can just buy the longer ones?
They cant be "dropped down" but thats true if you glue two aswell

Skickat från min SM-G955F via Tapatalk

[Nickhofen]

I'm going to glue 2 T nuts together so they can't twist in the slot for my clamps to make it easier to release, move and retighten.

Is that M6 thread with a 10mm slot?

Those are M6 with 8mm slot, they was suppose to be 19.5mm but actually they are 19.28mm.

[Desertboy]

If you have a router table make them yourself that's my plan if I ever need to mount hiwin's again with extrusion.

But if you need more I can get them from KJN and post them to you for cost I'm 3 miles (4km) away from them and need to go for more T nuts this week for my clamps so it;s no hassle.

They're £4 for 10 I needed 100 for my hiwin's so I bitterly know this lol.



Took this in their entrance, this would cost stupid money lol. Extrusion is not cheap.

[Nickhofen]

I'm going to glue 2 T nuts together so they can't twist in the slot for my clamps to make it easier to release, move and retighten.

Is that M6 thread with a 10mm slot?

Why didn't you write that yesterday???