1200mmX900mmX170mm 4axis cnc

[Nickhofen]

I'm going to glue 2 T nuts together so they can't twist in the slot for my clamps to make it easier to release, move and retighten.

Is that M6 thread with a 10mm slot?

Those are M6 with 8mm slot, they was suppose to be 19.5mm but actually they are 19.28mm.

[Desertboy]

If you have a router table make them yourself that's my plan if I ever need to mount hiwin's again with extrusion.

But if you need more I can get them from KJN and post them to you for cost I'm 3 miles (4km) away from them and need to go for more T nuts this week for my clamps so it;s no hassle.

They're £4 for 10 I needed 100 for my hiwin's so I bitterly know this lol.



Took this in their entrance, this would cost stupid money lol. Extrusion is not cheap.

[Nickhofen]

If you have a router table make them yourself that's my plan if I ever need to mount hiwin's again with extrusion.

But if you need more I can get them from KJN and post them to you for cost I'm 3 miles (4km) away from them and need to go for more T nuts this week for my clamps so it;s no hassle.

They're £4 for 10 I needed 100 for my hiwin's so I bitterly know this lol.



Took this in their entrance, this would cost stupid money lol. Extrusion is not cheap.

Thanks mate,that is very kind of you, I appreciate it.
For now I am good but I will keep in mind your offer, thanks again!!!

[Nickhofen]

Where can I find HDT5 pulleys with 10mm bore, any suggestion?

[Chaz]

Where can I find HDT5 pulleys with 10mm bore, any suggestion?

http://www.beltingonline.com - Very good to deal with.

[Nickhofen]

http://www.beltingonline.com - Very good to deal with.

Thanks for the reply, are there any pulleys with a 10 mm hole already in the middle,or I am missing something,I can find only with 6 and 8 mm HDT5 pulleys at beltingonline.

[Clive S]

Thanks for the reply, are there any pulleys with a 10 mm hole already in the middle,or I am missing something,I can find only with 6 and 8 mm HDT5 pulleys at beltingonline.

They quite often just have pilot hole but have you asked them if they can bore them out for you, don't forget grub screws

I have just checked http://www.beltingonline.com/20-toot...20-5m-15f-7776 there is an option for the boring and grub screw holes. bit expensive thou , not hard to do.

[wallyblackburn]

Where can I find HDT5 pulleys with 10mm bore, any suggestion?

Not sure if this helps, but I just ordered some on eBay in US. from China:

https://www.ebay.com/itm/HTD-5M-20T-...72.m2749.l2649

I figured they wouldn't ship until after Chinese New Year, but they are supposedly on their way. Obviously, I can't yet speak to quality...

Regards,
Wallace

[Nickhofen]

Thanks Wallace, I will check them!