Quote Originally Posted by magicniner View Post
I always fid HSM Advisor gets me in the ballpark straight away.
Are you sure that the corners are wearing off the carbide endmill and it's not another mechanical mode of failure?
I just looked at hsm.
Is it only available for pc or can i get it on my phone?
As for cutter wear im not sure what is going on other than i cannot get a good chip to come off the material.
All i can get is small hard chips which wear the cutting faces.
I tried full depth cut but im not getting my usual long thin chips off of it.
Its as if the en24t has work hardened in the turning stage