Threaded View
-
15-05-2017 #2
I have a Chinese belt drive unit which I re-engineered with shaft support bearings and a belt tensioner, with a steel re-enforced belt it has no backlash and has the potential for decent through capacity which the harmonic drive models cannot.
You think that's too expensive? You're not a Model Engineer are you? :D
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Emco Unimat Milling Head Conversion
By magicniner in forum Milling Machines, Builds & ConversionsReplies: 0Last Post: 30-07-2016, 09:04 PM -
Mach3 G76 head scratcher
By GeoffV in forum Artsoft Mach (3 & 4)Replies: 14Last Post: 26-03-2014, 05:41 PM -
NEW MEMBER: In over my head
By Tele45 in forum New Member IntroductionsReplies: 8Last Post: 03-01-2014, 02:30 PM -
diy Engraving head
By riche543 in forum Metalwork Project ShowcaseReplies: 2Last Post: 25-06-2012, 01:31 PM -
VA4 Vertex users
By fragger6662000 in forum Milling Machines, Builds & ConversionsReplies: 1Last Post: 25-09-2011, 10:11 PM
Bookmarks