Router Build Mk 1

[Desertboy]

There are plenty of us using belt drive without backlash issues. Properly set up amd with the proper belt/pulley combination, backlash isn't a problem with belts. I use two drive motors for the master and slave X axis ballscrews on my router with short belts but there are quite a few builders who have gone for one motor with a long belt which works fine. I think that you should make the direct/belt drive choice based on other factors. I went belt drive as it meant that my motors are tucked in inside the overall build envelope, I can change drive ratios if I need to, and I get a bit of isolation of motor stepping from the ballscrew. It's also easier to build and adjust mechanically. Direct drive means very careful alignment (even if you are using Oldham/Lovejoy/flexible couplings). Both are viable methods but be aware of all the trade-offs before deciding.

I've scrapped quite a few commercial printers over the last 5 years and I keep seeing the same thing, the main drives are direct drive by either ballscrews or often leadscrews. The ink is always delivered by nema 23 using belt drive with tensioners gearing to ~4 to 1. With a properly setup up belt tensioner I can see backlash is so slight as to be negligible. Thing is though making any system backlash free is a major hassle and even ballscrews exhibit backlash over time as the bearings wear unless using a 2 nut style system. The reality is though most people won't even notice minor backlash and if you can notice it then you have more than minor backlash lol.

What put me off was the belt tensioner, it's easier for me to direct drive then belt drive.