Thread: solid cam post processor help
-
22-05-2017 #1
I'm using solid cam, and i have parts to machine which are minute, the screen shot is what i get on solid verify and looks awful .the bit is down to 0.50 ball endmill if i try a smaller bit it looks even worse. the first screen shot is a section of the part and the other is what i see in solid verify.
Last edited by kell; 22-05-2017 at 06:34 AM.
-
23-05-2017 #2
How small is your stepover? You seem to be stepping over the whole diameter of the cutter by the looks of your graphics. For a ballnosed cutter you only need a stepover of 0.05-0.1mm.
Sent from my iPad using Tapatalk
-
02-06-2017 #3
sorry for late reply i was away. I have now changed a setting and the tool works great in it, the problem is i am not sure of the setting i have changed because when i repeat the operation with the same tool it misses a section again.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
HSMWorks and HSMXpress: post processor editing
By Mad Professor in forum CAD & CAM SoftwareReplies: 5Last Post: 16-12-2016, 11:05 AM -
Post Processor for Heidenhain tnc 145???
By jackpat in forum CAD & CAM SoftwareReplies: 15Last Post: 04-07-2016, 10:17 PM -
Help with Post Processor
By superpot in forum CAD & CAM SoftwareReplies: 0Last Post: 20-11-2013, 11:23 AM -
Vectric Post Processor
By p1lts in forum General DiscussionReplies: 2Last Post: 08-10-2011, 08:02 PM -
Post processor Sei
By 2006Nobull in forum Machine DiscussionReplies: 12Last Post: 04-08-2011, 12:58 PM
Bookmarks