big budget cnc

[Davek0974]

For your HiWin, look into AliExpress, guy called BST Automation, thats where i got mine from.

R&P can be done well and is good on long machines - to get good accuracy look to anti-backlash pinions, they are like two pinions with a spring twisting them apart so the tooth is under tension all the time.

To check what screw, look at the speed/whip rating, longer they go the thicker they need to be, you can also tension the screw to stop whip.

[Boyan Silyavski]

Just as a side note - 20 size Hiwin for all axis is ok. No need for 25 size. Ball screws: 1605 for the Z, 1610 or faster for the X, 2510 or faster for the Y and A long ballscrews and rotating nut setup. I dont see a point for faster ball screws though than xx10 for a Do-ALL-Machine

[pet30]

Very interesting

https://www.youtube.com/watch?v=fwbkWM0mWfs

what are your opinions for this type of linair rails? could i use them

my budget was about 2000€ but i think i will need a lot more.

[Desertboy]

Very interesting

https://www.youtube.com/watch?v=fwbkWM0mWfs

what are your opinions for this type of linair rails? could i use them

my budget was about 2000€ but i think i will need a lot more.

Looks a lot better than makerslide but still not proper rail! If you want actual production you need to expand you budget

I think if you double the budget you could build a very decent machine

[Boyan Silyavski]

That rails could be good for a month, but will need constant tweaking later. Its a better solution than roller bearings or V rails but... I dont know how you value your time but when actually working, any hit and miss day will cost you hundreds of $$$ missed profits.

My opinion again is to buy used machine, some times people from forum sell good ones. or pay sb to do it for you and start making money from day 1. Yes i build my machine, but it was a do-all-extraordinary and if i have to buy similar i have to pay more than 20k for it so there was a reason for the wait. But for pure woodworking, i wouldn't think twice and buy even Chinese, so to start making money faster

[pet30]

Bying a cnc here is stil 20.000 euro or its a old machine etc.
I will go for the supported rails not the bearings.

Now the problem is i still have that big gantry of 3000 mm

How would you guys make that gantry strong so it don't flex and twist?

if its really difficult then i have to turn the machine 90° so the gantry is 1600 mm .

[Desertboy]

I'd extend the frame a little so the gantry can move out the way completely so you can remove the work piece then it's irrelevant which way the gantry is. If you mount the hiwin's and ballscrew on the sides you can enclose them enough that when you access the piece it's not an issue.

Go for 1.6m gantry NOT 3m simple any other choice is just nuts.