big budget cnc

[Boyan Silyavski]

this is the short motor. You need the longer Nema 23 . Could buy it from Uk, Price is good and they have full kit with drives, https://www.cnc4you.co.uk/Stepper-Mo...YGH301B-Nema23

[pet30]

could this one work ?

[Boyan Silyavski]

could this one work ?

it could but is not the ideal. I pointed you the previous message to the ideal. Building the CNc you can make like 500 mistakes. When you are not sure which, what why, just follow the recommendations :-) or look more carefully into the data. And when you dont know what it means, follow the ...

[pet30]

witch driver is the best for those stepper motor's ?

can i use arduino uno with the drivers?

its because i want to use estlcam and it works with arduino uno or xPRO V3 Controller Stepper Driver so can i use these with the drivers?

[Clive S]

witch driver is the best for those stepper motor's ?

can i use arduino uno with the drivers?

its because i want to use estlcam and it works with arduino uno or xPRO V3 Controller Stepper Driver so can i use these with the drivers?

AM882 are a good choice for the drivers. With 68V power supply.
Why would you want to use arduino uno to run a router?
Any software will work with the drivers.

[pet30]

Got the steel since friday i was a lot and very heavy.
this weekeind i started to weld everything together with a small inverter and it works very well.
Just a question do i need to bolt the machine to the floor ? do i need to put rubber between the bottom of the legs and the floor to have the less vibrations?

[Clive S]

Just a question do i need to bolt the machine to the floor ? do i need to put rubber between the bottom of the legs and the floor to have the less vibrations?

No. No need to bolt the machine to the floor I have mine on castors but when it is in place I lift it off the floor on wooden blocks otherwise it would walk about.