Quote Originally Posted by piper1 View Post
Did a couple of test runs this afternoon, one with the spindle running and one without
Both ran the exact program, same length of time etc and not not a glitch in sight.
Both test ran flawlessly, i was so made up.

The only thing i did in the hope to remedy the fault with the machine stopping during programs was to move the USB cable away from any other possible interference's (cables).

Going to run the same program again tomorrow with the machine cutting this time , fingers crossed.

Thank you for the advise Lee.
Sweeeet!

Hopfully the next test works fine, Clive is right as well grab yourself a nice USB cable about the right length, you dont need to spend crazy money getting some gold plated, braided bad boy, something like this should do: Hama USB Cable Blue 5m

Keep us posted its nice to know when something gets fixed :)