. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 27-06-2017 #2
    AndyGuid's Avatar
    Lives in Pakenham, Melbourne, Australia.
    AndyGuid
    Current Activity: Viewing MYCNCUK Has been a member for 9-10 years. Has a total post count of 214. Received thanks 34 times, giving thanks to others 300 times.
    Afraid I can't answer your question and I suspect that most on this forum have not yet delved into the world of Arduinos and open source software/firmware, but hopefully someone does have the knowledge to come along and help.

    Welcome to the forum though :-)
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to AndyGuid For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Which cables to shield?
    By andy586 in forum General Electronics
    Replies: 0
    Last Post: 02-07-2014, 04:33 PM
  2. Any arduino coders here?
    By Mad Professor in forum General Electronics
    Replies: 48
    Last Post: 25-03-2013, 06:07 PM
  3. CNC Controller with Arduino and Gamepad
    By Christian Knuell in forum Electronic Project Building
    Replies: 2
    Last Post: 20-10-2012, 10:25 PM
  4. ​DIY arduino CNC 2 axis table
    By ruthharm84 in forum Electronic Project Building
    Replies: 5
    Last Post: 06-05-2012, 01:54 AM
  5. Minimal-cost Power Supply Strategy - Repurpose Laptop Power Supplies
    By LoveLearn in forum General Electronics
    Replies: 0
    Last Post: 25-01-2012, 09:29 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules