Threaded View
-
23-08-2017 #21
Last Activity: 13-07-2023
yeah those are your drivers, what you referred to in an earlier post as your new driver board is actually your motion control board.
Again, only working from educated guesses given the blurry pics on their website an no instructions, but you have two variables you can set on those drivers. micro stepping and amps. the micro stepping looks like it is set by the small dip switch, which leaves the red jumper for amps. one assumes the different jumper positions correspond to 0.5, 1.0, 1.5, 2.0 and 2.5 amps... if that is a correct assumption then you'd want the second from last pins if your motors are indeed 2.0ALast edited by Zeeflyboy; 23-08-2017 at 08:36 AM.
-
The Following User Says Thank You to Zeeflyboy For This Useful Post:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
3020T Capabilities
By TT901 in forum Chinese MachinesReplies: 6Last Post: 03-03-2017, 04:20 PM -
Chineese 6040 problems
By Kendrick57 in forum Gantry/Router Machines & BuildingReplies: 18Last Post: 18-10-2015, 10:52 PM -
Ballscrew for 3020T Y Axis
By richie00boy in forum Lead Screws, Nuts & SupportsReplies: 5Last Post: 02-08-2013, 02:47 PM -
A viable mini-ish-mill build, or a hiding to nothing..?
By Wal in forum Milling Machines, Builds & ConversionsReplies: 3Last Post: 02-07-2013, 07:33 PM -
Where did you buy your threaded rod?(cheapo leadscrew!) - was it straight?
By HankMcSpank in forum Marketplace DiscussionReplies: 18Last Post: 04-06-2009, 03:44 PM
Bookmarks