Threaded View
-
23-01-2018 #8
Last Activity: 10-01-2019
Hi,
I'm also using TB6600 based controllers... these super-cheap ones:
and they're fine apart from after about 10 minutes any of X/Y axes will die, all indicator lights off on driver, until I power cycle it. They don't seem very warm and they don't auto-recover as you might expect if it were overheating. It's perhaps too different from your circuit but maybe someone here recognises the problem.
Over current? Totally dodgy circuit / waste of money?
Any suggestions appreciated!
(36v 15A power. driving fine using GRBLv1.1. Failed on highest power and the one down from that)
PhilLast edited by davies46; 23-01-2018 at 01:38 AM.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
TB6600 vs. CW5045
By eurikain in forum Motor Drivers & ControllersReplies: 0Last Post: 04-10-2015, 12:23 PM -
How hot do TB6600 drivers run normally ?
By KevinK in forum Motor Drivers & ControllersReplies: 4Last Post: 20-09-2015, 03:50 PM -
Pcb-linear motion solutions
By kyris31 in forum Gantry/Router Machines & BuildingReplies: 2Last Post: 20-02-2013, 10:14 AM -
The reason of noise of Engraving machine and solutions
By Tomas in forum Machine DiscussionReplies: 0Last Post: 26-08-2011, 10:41 AM -
Delcam Advanced Manufacturing Solutions
By Andywarwick in forum Manufacturer NewsReplies: 0Last Post: 06-06-2011, 04:48 PM
Bookmarks