Threaded View
-
23-01-2018 #14
Last Activity: 10-01-2019
OK thanks, I just bought two that look just like that, with the higher voltage and current rating. I can replace the optos as this thread details.
Meanwhile, I just ran a large job at 2x speed and it made it through the job twice without tripping, so maybe I'll be OK for milling polystyrene - will wait a while before putting the actual lump of wood under it though!
-Phil
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
TB6600 vs. CW5045
By eurikain in forum Motor Drivers & ControllersReplies: 0Last Post: 04-10-2015, 12:23 PM -
How hot do TB6600 drivers run normally ?
By KevinK in forum Motor Drivers & ControllersReplies: 4Last Post: 20-09-2015, 03:50 PM -
Pcb-linear motion solutions
By kyris31 in forum Gantry/Router Machines & BuildingReplies: 2Last Post: 20-02-2013, 10:14 AM -
The reason of noise of Engraving machine and solutions
By Tomas in forum Machine DiscussionReplies: 0Last Post: 26-08-2011, 10:41 AM -
Delcam Advanced Manufacturing Solutions
By Andywarwick in forum Manufacturer NewsReplies: 0Last Post: 06-06-2011, 04:48 PM
Bookmarks